03-05-2012 04:43 PM
I'm having the following problem with this printer:
As the printer was warming up there was a loud “thunk” (sound like someone dropped the printer from a height) and after that the printer “screeched” (sounded like the rollers were not spinning properly) and reported a paper jam. I cleared the initial jam and heard the same “screech” and received another paper jam warning.
After turning off and back on, the printer jams with the paper being stuck in the front. The rollers look like they need to be replaced, but I have not done that yet.
Now after moving the printer and replacing the maintenance kit, it now give me the following error, even after a power cycle: error 07,010.43:156835. I can't clear or move past the error.
google doesn't turn up anything for that code, please help!
03-08-2012 06:10 PM
Thank you for using the Support Forum. I looked at the support page for your machine and did a search on the code you are receiving, here is the solution I found. It looks like you may need service at this point.
03-12-2012 05:06 PM
Thanks for the reply, I probably will need service. I found through taking off the covers of the unit and reading this site (http://www.fortwayneprinterrepair.com/wordpress/20
"The process drive unit is the gear assembly on the front right side of the printer with the clear plastic cover. Grab a hold of the assembly and try to slightly move it to check and make sure the three mounts holding it into place aren’t broke. If it moves or you notice one of the post are broke then you will need to purchase the drive mount repair kit."
I have ordered a repair kit and will try it out.